|  INCREASES
AIRFLOW
The ZEX™ Ejector Air Amplifier™
is the first air induction system to harness the kinetic
energy of nitrous oxide. As the high-speed nitrous gas
exits the nozzle in the end of the filter, the stream
“captures” the surrounding air and induces
a significant increase in airflow. Tests show increases
of 50 cfm with just a 75 hp shot of nitrous. This airflow
increase maximizes the potential of your engine’s
air induction system!
EASES
NITROUS KIT INSTALLATION
The other great benefit of the Ejector
is that it greatly simplifies a dry nitrous kit installation.
No longer do you have to drill and tap your intake tube
for a standard nozzle, just slide the ZEX™ Ejector
Air Amplifier™ in place of your standard cone
filter and your ready to spray. This means in just a
few minutes, you can be enjoying the benefits of airflow
enhancing nitrous injection!
WASHABLE
& REUSABLE
The Ejector’s design has been incorporated
into a race quality air filter that is washable and
reusable. This level of quality ensures that you will
not only have the most efficient method of nitrous injection,
it will be the last air filter you’ll ever have
to buy!
INSTALLATION
INSTRUCTIONS
TOOLS
REQUIRED
Flat blade screwdriver
7/16" open end wrench
NOTE:
If you are installing the ZEX™ Ejector Air Amplifier™
in conjunction with a new dry nitrous system installation,
you will not have to install the nozzle that comes with
your nitrous kit. The Ejector will be used in place
of that nozzle. If you are installing the Ejector in
a vehicle that already has a dry nitrous system installed,
you simply have to remove the current dry nozzle and
plug the hole the nozzle came out of. If you would like
to install the Ejector before you have a nitrous system
installed on the vehicle, you can simply cap the nozzle
jet fitting in the end of the Ejector with the cap fitting
supplied in the kit.
Step
1:
Remove the standard air filter element from the end
of the air intake tube. Install the ZEX™ Ejector
Air Amplifier™ in its place using the silicone
connector piece and the hose clamps that are provided.
Step 2:
If installing the Ejector in a vehicle that already
has a dry nitrous system installed, disconnect and remove
the short –3 AN connection hose that goes from
the nitrous kit to the dry nitrous nozzle. Remove the
nitrous jet that is in your nozzle and place it in the
end of the Ejector’s nozzle jet fitting. Using
the longer –3 AN connection hose that comes with
the Ejector kit, connect the nitrous system to the nozzle
jet fitting in the end of the Ejector.
Step 3:
Remove the nitrous nozzle from the air intake and properly
plug the hole.
That
completes the installation of the ZEX™ Nitrous
Air Amplifier™, enjoy your NEW LEVEL OF NITROUS
PERFORMANCE!
|